Zebra 110PAX4 Guia do Utilizador descarregar pdf (Página 29)

Print Engine Setup

Print Engine Installation

6/29/11 110PAX4/R110PAX4 User Guide 57512L-004 Rev. A

Figure 8 • Top View of Right-Hand Print Engine

Install the Print Engine in an Applicator

This section provides the basic instructions for installing the print engine into an applicator.

To install the print engine into an applicator, complete these steps:

1. See Figure 9. Install the center mounting bolt into the center hole on the applicator.

2. Carefully place the keyhole on the center mounting bolt.

Caution • If the print engine is installed improperly, it could fall out of the applicator and

cause injury. The center mounting bolt and four mounting screws must be installed and

secured. See Figure 9 for the location of the bolt and screws.

Note • The keyhole and the center mounting bolt are designed to support the print engine

and assist in installing and removing the four mounting screws.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 163 164

Sem comentários

Zebra 110PAX4 Guia do Utilizador Página 29