Zebra 170PAX2 Series Guia do Utilizador descarregar pdf (Página 13)

10. Rotate the peel roller assembly (J) up until it latches closed.

11. Thread the backing material under the lower guide post (M) and around the take-up

spindle of the applicator (refer to the applicator’s user’s manual).

Ribbon Loading

To load ribbon, refer to Figure 4 on page 12 (for right-hand units) or Figure 5 on

page 13 (for left-hand units).

NOTE: Do not load ribbon if the print engine is to be used in the direct thermal

mode.

CAUTION: When installing the ribbon roll on the ribbon supply spindle, make

sure to push the ribbon roll against the stop with the ribbon aligned squarely with

its core. Do not use ribbon narrower than the media. If the printhead is not pro-

tected by the smooth backing of the ribbon, premature printhead failure may

result due to excessive abrasion.

Right Hand Units

1. Push the ribbon roll onto the supply spindle (N) as far as it will go, so the ribbon

feeds as shown in Figure 4 on page 12.

2. Install an empty ribbon core onto the ribbon take-up spindle (O).

3. Open the printhead assembly (C) by unlatching the print- head lock lever (D) from

the locking pin (E).

4. Thread the ribbon below the lower ribbon guide roller (P), under the printhead

assembly (C), and up and over the upper ribbon guide roller (Q) as shown in Figure

4. Use caution not to crease or wrinkle the ribbon!

5. Attach the ribbon to the take-up spindle core (use a label if needed) and wind for

several turns in the direction shown in Figure 4.

6. Close the printhead assembly (C) by latching the printhead lock lever (D) onto the

locking pin (E).

7. Insure the ribbon is located between the Ribbon Sensor and the Sensor Reflector

positioned above it.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 99 100

Sem comentários

Zebra 170PAX2 Series Guia do Utilizador Página 13