Zebra Wireless Print Server Guia do Utilizador descarregar pdf (Página 45)

ZPL Commands for the Wireless Print Server

^NS

9/29/05 Wireless Print Server User Guide 13422L-002 Rev. B

^NS

Change Wired Networking Settings

Description Use this command to change the wired print server network settings.

Format ^NSa,b,c,d,e,f,g,h,i

The following table identifies the parameters for this format.

Parameters Details

a = IP Resolution Accepted Values:

A (ALL)

B (BOOTP)

C (DHCP AND BOOTP)

D (DHCP)

G (GLEANING ONLY)

R (RARP)

P (PERMANENT)

Note • Use of GLEANING ONLY is not recommended when the Wireless

Print Server is installed.

b = IP Address Accepted Values: Any properly formatted IP address in the xxx.xxx.xxx.xxx

format.

c = Subnet Mask Accepted Values: Any properly formatted subnet mask in the xxx.xxx.xxx.xxx

format.

d = Default Gateway Accepted Values: Any properly formatted gateway in the xxx.xxx.xxx.xxx

format.

e = WINS Server Address Accepted Values: Any properly formatted WINS server in the xxx.xxx.xxx.xxx

format.

f = Connection Timeout

Checking

Accepted Values: Y (YES), N (NO)

g = Timeout Value

Time, in seconds, before the connection times out.

Accepted Values: 0 through 9999

h = ARP Broadcast

Interval

Time, in minutes, that the broadcast is sent to update the device’s ARP cache.

i = Base Raw Port Number

The port number that the printer should use for its RAW data.

Accepted Values: 0 through 99999

Default Value: 9100

Example •

^XA

^NSa,192.168.0.1,255.255.255.0,192.168.0.2

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 93 94

Comentários a estes Manuais

Sem comentários

Zebra Wireless Print Server Guia do Utilizador Página 45

Comentários a estes Manuais

Manuais e produtos relacionados com Servidores de impressão Zebra Wireless Print Server