Zebra LP2824 Plus Guia do Utilizador descarregar pdf (Página 73)

Maintenance

Cleaning

4/1/09 LP 2824 Plus™ User Guide 980644-001 Rev. A

3. Lift the platen out of the printer’s bottom frame.

4. Clean the platen with the alcohol moistened swab. Clean from the center out. Repeat this

process until the all of the roller surface has been cleaned. If there has been heavy

adhesive build-up or label jam, repeat with a new swab to remove residual contaminates.

Adhesives and oils, for example, may be thinned by the initial cleaning but not completely

removed.

5. Install the platen in the printer. Discard the cleaning swabs after use - do not reuse.

6. Make sure the bearings and drive gear are on the shaft of the platen.

7. Align the platen with the gear to the left and lower it into the printer’s bottom frame.

8. Rotate the platen bearing latch release tabs down on the right and left sides towards the

rear of the printer and snap them into place. Allow the printer to dry for one minute before

closing the dispenser door, media cover or loading labels.

Other Printer Maintenance

There are no user level maintenance procedures beyond those detailed in this section. See the

Troubleshooting on page 67 for more information on diagnosing printer and print problems.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 97 98

Sem comentários

Zebra LP2824 Plus Guia do Utilizador Página 73