Zebra 170PAX4 Guia do Utilizador descarregar pdf (Página 138)

Data Ports

Applicator Interface Connector

130

57516L-002 Rev. A 170PAX4 User Guide 1/10/06

11 END PRINT Output See Applicator Signals on page 126 for more information

about the start and end print signals. See Set Applicator

Port Mode on page 76 for more information about the

modes.

• MODE 0—The applicator port is OFF.

• MODE 1—Asserted LOW only while the print engine

is moving the label forward; otherwise deasserted

HIGH.

• MODE 2—Asserted HIGH only while the print engine

is moving the label forward; otherwise deasserted

LOW.

• MODE 3—(Default) Asserted LOW for 20

milliseconds when a label is completed and positioned.

Not asserted during continuous printing.

• MODE 4—Asserted HIGH for 20 milliseconds when a

label is completed and positioned. Not asserted during

continuous printing.

12 MEDIA OUT Output Asserted LOW while there is no media in the

print engine.

13 RIBBON OUT Output Asserted LOW while there is no ribbon in the

print engine.

14 DATA READY Output See Applicator Signals on page 126 for more information

about this signal.

• Asserted LOW when sufficient data has been received

to begin printing the next label.

• Deasserted HIGH whenever printing stops after the

current label, due to either a pause condition or the

absence of a label format.

15 SPARE Output To be determined.

Table 19 • Applicator Interface Connector Pin Configuration (Continued)

No.

Signal Name Signal Type Description

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 163 164

Sem comentários

Zebra 170PAX4 Guia do Utilizador Página 138