Zebra 2746e Manual do Utilizador descarregar pdf (Página 53)

Mounting the

Cutter

Use this procedure to attach and remove a pre

-

viously installed cutter on the printer. The oper

-

ator should reverse the procedure to remove

the cutter.

Step 1 Open the media access door.

Load and set media parameters (via AutoSense

or programming with the Q command) in the

printer.

Step 2 Remove the lower front cover. Lift up on the

lower front cover while holding down the

printer’s base. The cover will un-snap with

steady upward pressure and slide up and out.

Using the Media Cutter

980412-001 Rev.A C-3

Lift (1)

Pull Out (2)

Reverse the process to re-install

the lower front cover

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 65 66

Comentários a estes Manuais

Sem comentários