Zebra TTP2130 Especificações descarregar pdf (Página 63)

Programming

Software command syntax

10/22/2008 TTP2100 Technical Manual P1003640-001

Effects paper cut-off only.

Eject can be effected with the ESC FF n command (see 49) which also activates the pull

detector.

To avoid thin strips of paper in the printer, multiple cut commands without paper feed in-

between will not be performed. If the printout length is too short, paper-feed is added until the

minimum printout length is reached, before execution of the cut command.

See Also Note on cut position for the <RS> command above.

The US command triggers printout of data, then prints a dotted line and a pair of scissors, and

partially cuts the paper from both edges towards the center to make it easier to tear off the

paper.

The length of the partial cut can be set with parameter n60.

ESC FF ejects the document through the presenter module. Variable n represents the eject-

length in steps. The setting of parameter n47 is always added to the eject n in all forms of

eject.

The range for n is 1 to 127. The range 128-255 is reserved for future use.

ESC RS



Cut Only, No Eject

1B 1E Hex

27 30 Decimal

Note • Use the cut command if you want full control over the printer from your system. But

remember that you also must add commands to feed to the correct cut position and eject the

paper so that the customer can get hold of it.

Note • Top margin settings that move the paper count as paper feed.



Partial Cut (Unit Separate)

1F hex

031 decimal

ESC FF n1

Eject (Run Presenter)

1B 0C n1 hex

27 12 n1 decimal

Kiosk

wall

n47

Eject n

Printer

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 137 138

Sem comentários

Zebra TTP2130 Especificações Página 63