Zebra KR403 Especificações descarregar pdf (Página 38)

Setting Printer Behaviors

Printer Settings - Tools Tab

P1026208-001 Rev. B Software Integrator Guide 10/29/2010

Windows Driver Limitations

The Windows driver for Zebra kiosk printers supports the most common printer behaviors.

All commands and printer configurations are not supported. This driver only supports kiosk

printer media handling which is set by the

^MMK - see the Print Mode command in the ZPL

Programmers manual for your kiosk printer for more details. It does not support the

Rewind (a more descriptive term would be ‘no rewind’) or Cutter Print Modes also

supported by the kiosk printer and are typically used for label printing.

Printer Settings - Tools Tab

This tab in the driver controls the printer’s mounting orientation (horizontal -default or

vertical), preparing the printer for use (restore factory defaults and printer reset to clear

settings), print status receipts, send commands to the printer, and communications

diagnostic mode.

To use one of the Printer Command Tools, select a Command Type (Action or Print group)

and then select a command from the Command Name list. Press the Send button on the

bottom of the driver’s tab window.

• When you are beginning a new prototype receipt, it is always a good idea to

restore the printers default setting and then reset the printer (with this tab

window).

• If you are using Black Mark/Line media, the printer should be calibrated for this

media type. Use the Action - Send Command Tools selection to Send the printer

the following command line (a printer configuration format):

^XA^MNM,0^JUS^XZ

Figure 4-1 • Printer Properties

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 157 158

Sem comentários

Zebra KR403 Especificações Página 38