Zebra S-500 Guia do Utilizador descarregar pdf (Página 12)

Communications

The Stripe comes with either an Electronics Industries Association (EIA) RS-232 serial

data interface or a factory-installed parallel interface. In both cases, you must supply

the required interface cable for your application. See the Appendix for specific cable

requirements.

CAUTION: Zebra printers comply with FCC “Rules and Regulations”, Part 15, Subpart

J, for Class A Equipment, using fully shielded six-foot data cables. Use of longer cables

or unshielded cables may increase radiated emissions above the Class A limits.

Cutter Module Interface

(For Stripes with the Factory-Installed Cutter Option)

The Cutter Module connects to the printer via a standard 8-pin connector.

The cable on the front of the printer plugs into the connector on the bottom of the Cutter

Module once the Cutter Module has been installed.

Getting Started

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 79 80

Sem comentários

Zebra S-500 Guia do Utilizador Página 12