Zebra TTPM2 Manual do Utilizador descarregar pdf (Página 5)

( |, {, and } )

Only dual track version:

Does not accept ticket data without track selection command. !L1, !L2, !L17, or

!L18 must always be sent prior to every !P command. Signals NAK 1 to indicate

error and discards the received data.

Bug fixes

•

Response to entry selection with one ACK instead of two ACK.

•

Now responds to lower entry selection when there is no paper present.

•

Response to paper jam while selecting entry is now NAK + 2 instead of

NAK + 2 + ACK

Restrictions

Same as 906-290

3.30

!F T modified with fixed spacing setting for font 1.

New commands !Q, !U, !V and !N+

New error message NAK X

Added power ON ticket detection routine that voids any ticket left in the printer at

power OFF.

An "ETX" (03H) is issued when the print cycle is completed.

3.50

!W print progress indication command added, and improvements to the power

failure cleanup.

Only barcodes of size 1 and 2 printed in east and west orientation will reduce print

speed.

3.60

!Y "read ticket counter" command added

3.70

Characters added to positions 128 to 255 of fonts 1 and 4. Among them is the Euro

symbol ( € ) in position 128. See Technical Specifications Manual for complete

character set.

3.80

A ticket inserted in the rear upper slot before the TTPM2 has received a load

command causes the red LED to start flashing and the TTPM2 waits for the ticket to

be removed before continuing. To prevent a ticket that has been left sitting at the

mouthpiece from being sucked in when a front load command (!L3) is received, the

TTPM2 now senses if there is a ticket already in the mouthpiece when the !L3 is

received and in that case it flashes the red LED until the ticket has been removed.

3.90

Fix added for the problem where the printhead were left in a raised position Default

burn time has been reduced. A new command (!Z n) controls the burn time

(blackness).

NOTE! - After installing this firmware you MUST do a three-button reset for it to

set the burn time to the default value. Failing to do so will generate blank tickets

Inserting a ticket at the rear upper slot after an !L3 command is prevented in CD-

mode.

New transmission speed introduced: 115200 baud.

4.00

Default burn time is now automatically set after firmware upgrade.

Upper solenoid activated during single ticket entry on Dual entry printers that are

1 2 3 4 5 6

Comentários a estes Manuais

Sem comentários