Zebra TTPM2 Manual do Utilizador descarregar pdf (Página 19)

0309 TTPM2 Technical Specification 19

!L3 Loads document through front entry

!L4 Ejects document through front entry

!L5 Transports document to waste bin (only for printers with front load 2 and 3)

!L17 Selects lower rear document entry and signals if paper is out (for units with dual

consecutive entries

)

!L18 Selects upper rear document entry and signals if paper is out (for units with dual

consecutive entries

)

!T Sets timeout for retract function

7.2.3 Print-parameter related commands

!F T Print text

!F G Print graphics

!F C Print bar code

!F M Specifies No. of retries + cancellation text to be printed if encoding fails

7.2.4 Magnetic encoding/decoding related commands

!D Reads and decodes data in ISO format from track 2 (or center track)

!D1 Reads and decodes data in ISO format from track 1

!D3 Reads and decodes data in ISO format from track 3

!I Defines data to be encoded in ISO format on track 3

!J Defines data to be encoded in ISO format on track 1

!K Defines data to be encoded in Hex format on track 1 or 3 (as applicable)

!M Defines data to be encoded in ISO format on track 2 (or center track)

!N Defines data to be encoded in hexadecimal format on track 2 (or center track)

!N+ Same as !N but reverses the bit order

)

!O Reads data in hexadecimal format from track 2 (or center track)

Introduced in firmware version 3.75

!L1, !L2, !L17 or !L18

must

be selected on units with dual document entries

Added in firmware version xxxxx-332

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

Sem comentários

Zebra TTPM2 Manual do Utilizador Página 19