Zebra TTPM2 Manual do Utilizador descarregar pdf (Página 29)

0309 TTPM2 Technical Specification 29

paper jam when the relative humidity changes the ticket width.

A ticket width of 53.98 ± 0.2 mm gives a maximum misalign-

ment of 0.65 mm (54.38 + 0.05 – (53.98 – 0.2)).

TIP!

– Avoid designing tickets that require close alignment between preprint and thermal

print.

13.3 Magnetic media

Magnetic stripe Side stripe positioned according to ISO 7811/2

Center track (option)

Magnetic media Full tape, transfer tape or slurry

CAUTION!

– In case of slurry, care must be taken to avoid excess slurry material and

abrasive particles that may cause unduly high degree of wear on the magnetic recording

and read heads in the TTPM2

Coercivity Low: 300 Oersted

High: 2750 Oersted (option)

Other non-standard coercivities available on request

If a ticket is perforated, for stub separation for example, the perforation shall not infringe

on the magnetic track to prevent interference with magnetically encoded data.

13.4 Ticket dimensions and perforation

Stock format Gapped or non-gapped consecutive Fanfold form tickets.

Sheet-cut (single) tickets for manual or dispenser loading.

Roll tickets with black marks or punched holes as top of form

indicators.

Perforation cut direction Perforation and cutting of ticket material must be done from the

thermally sensitive side of the paper.

Document standard ISO No. 7810

Ticket width 53.98 ± 0.20 mm

Ticket length 85.6 ± 0.25 mm, or 110.0 ± 0.25 mm

Corner radius 3.15 ± 0.3 mm (preferably without minus tolerance). Used for

optical detection of top-of form.

Perforation for stub Placed at the trailing end of the ticket

Gapped tickets Two tabs according to Figure 13.

Non gapped tickets Equal distance between tabs according to Figure 14.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Sem comentários

Zebra TTPM2 Manual do Utilizador Página 29