Zebra ZE500 Guia do Utilizador descarregar pdf (Página 33)

Introduction

Control Panel Display

8/23/12 P1051584-002

Set Applicator Error Signal When Print Engine Pauses

When this option is enabled and the print engine is paused, the

print engine sets the applicator error state.

See Error on Pause on page 80 for more information.

Set the Ribbon Low Mode

The Ribbon Low feature determines if the print engine will

generate a warning when the amount of ribbon left on the roll gets

low.

See Ribbon Low Mode on page 81 for more information.

Set the Ribbon Low Output

When the Ribbon Low feature is enabled, this parameter

determines if the output signal on Pin 9 is HIGH or LOW.

See Ribbon Low Output on page 81 for more information.

Set the Reprint Mode

When reprint mode is enabled, you can reprint the last label printed

either by issuing certain commands or by pressing the LEFT

ARROW on the control panel.

See Reprint Mode on page 81 for more information.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 169 170

Sem comentários

Zebra ZE500 Guia do Utilizador Página 33