Zebra 96XiIII Plus Especificações descarregar pdf (Página 10)

Ribbon Loading

When loading ribbon, make sure that the ribbon

core is pushed up against the stop on the Ribbon

Supply Spindle (Figure 5-D). Do not use ribbon

narrower than the media.

1. Align the segments of the Ribbon Supply

Spindle (Figure 8).

2. Place the Ribbon Roll on the Ribbon Supply

Spindle (Figure 8-D).

3. Make a leader for your ribbon. Tear off a strip

of media (labels and backing) about 15-30 cm

(6-12″) long. Peel off a label from this strip.

Apply half of this label to the end of the strip

and the other half to the end of the ribbon. This

acts as a ribbon leader.

4. Open (A) the printhead and thread the leader

and attached ribbon through the print

mechanism, under the Upper Roller

(Figure 8-K), and past the Platen (Figure 8-J).

Note: For the 170XiIII and 220XiIII, thread

the leader first through the Dancer Roller

Assembly (Figure 8-R).

5. Before wrapping the ribbon around the Ribbon

Take-Up Spindle, ensure that the arrow on the

knob aligns with the indented notch (see inset,

Figure 9).

6. Place the ribbon (with leader, if used) around

the Ribbon Take-Up Spindle (Figure 8-C) and

wind counterclockwise for several turns.

7. Close (Figure 8-B) the printhead.

82 English

Figure 8

E:\jobs\EH91 Zebra\XiIII\XiIII-gb.vp

Wednesday, December 15, 1999 8:55:47 AM

Color profile: Disabled

Composite Default screen

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Comentários a estes Manuais

Sem comentários