Zebra 96XiIII Plus Especificações descarregar pdf (Página 6)

Fuse Replacement

The XiIII-Series printer uses a metric-style fuse

(5 x 20 mm IEC) rated at F5A, 250V. The AC

Power Entry Module comes with two approved

fuses in the Fuse Holder: one is “In-Circuit” and

the second is provided as a “spare” (refer to

Figure 4). The end caps of the fuse must bear the

certification mark of a known international safety

organization (refer to Figure 2). To replace a

faulty fuse, use the following procedure.

Turn the AC power switch OFF and

remove the power cord before

performing this procedure.

1. Using a small blade screwdriver or similar tool,

remove the Fuse Holder which is part of the

AC Power Entry Module at the rear of the

printer. Refer to Figure 3.

2. Remove the faulty fuse and install a new fuse

in the “In-Circuit” position shown in Figure 4.

If you use the Spare Fuse, be sure to order a

new replacement fuse. Fuses can be ordered

from your Zebra distributor.

3. Snap the Fuse Holder back into the AC Power

Entry Module.

4. Reconnect the Power Line Cord and turn

printer ON.

Note: If AC power is not restored, an internal

component failure may have occurred. The

printer will require servicing.

78 English

SMALL BLADE

SCREWDRIVER

AC POWER

ENTRY

MODULE

FUSE

HOLDER

Figure 3

SPARE

FUSE

HOLDER

IN-CIRCUIT

FUSE

Figure 4

E:\jobs\EH91 Zebra\XiIII\XiIII-gb.vp

Wednesday, December 15, 1999 8:55:38 AM

Color profile: Disabled

Composite Default screen

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Comentários a estes Manuais

Sem comentários

Zebra 96XiIII Plus Especificações Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Impressoras de rótulos Zebra 96XiIII Plus