Zebra Z6Mplus Guia do Utilizador descarregar pdf (Página 62)

Operations

Load Ribbon

13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06

To load ribbon, complete these steps:

1. Set the ribbon supply spindle for normal or low tension.

• To place the ribbon supply spindle in the normal position, firmly pull out the spindle

end cap until it extends and clicks in place, as shown in Figure 21. Use this setting for

most applications.

• To place the ribbon supply spindle in the low-tension position, firmly push in the end

cap until it retracts and clicks in place, as shown in Figure 21. Use this setting when

using a narrow ribbon or if normal tension hampers ribbon movement.

Figure 21 • Ribbon Spindle—Normal and Low Tension

2. Press the printhead release latch to open the printhead assembly. Lift the printhead until it

latches open.

3. Orient the ribbon with the loose end unrolling clockwise.

Normal Position (Spindle End Cap Extended)

Low-Tension Position (Spindle End Cap Retracted)

1 2

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 165 166

Sem comentários

Zebra Z6Mplus Guia do Utilizador Página 62