Zebra TTPM3 Especificações descarregar pdf (Página 88)

Error Codes and Status Reporting

Status

P1003642-001 TTPM3 Installation and Programming Manual 01/06/2009

Status

When executing the print command !P, the printer confirms that the magnetic code is has been

written and verified by sending an ”

ACK” (06H) to the host. This indicates that the ticket in

almost ready and should just pass the printhead and be outputted to the customer. You can

extend the acknowledge procedure to send acknowledge for other things than magnetic

encoding. See command

!C A.

If you select a character by setting parameter 31, that character will be sent when the when the

print cycle is completed, which is when the ticket leaves the printhead. At this stage you can be

reasonably certain that the ticket has been correctly issued, and you can proceed with the next

ticket.

You can at any time

read the sensors in the printer with the “ENQ” (05H), and !S commands.

See ENQ on page 43.

1. After a power off, the printer must first receive a !C or !P before answering status queries.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 111 112

Sem comentários

Zebra TTPM3 Especificações Página 88