Zebra TLP2824 Plus Guia do Utilizador descarregar pdf (Página 34)

Getting Started

Loading Transfer Ribbon

980643-001 Rev. A TLP 2824 Plus™ User Guide 3/31/09

5. Rotate the thumb wheel on the left side of the ribbon frame by the supply spindle until the

ribbon is pulled tight across the printhead.

6. Verify that the media is loaded and ready to print and then close the printer cover.

7. Press the Feed button to have the printer feed a minimum of 10 cm (4 inches) of media to

remove slack and ribbon wrinkle, and to align the ribbon on the spindles.

8. Change the print mode setting from direct thermal printing to thermal transfer to set the

printer’s temperature profiles for thermal transfer media. This can be done with the printer

driver, application software, or printer programming commands.

• When controlling printer operations with ZPL programming, refer to the Media Type

(

^MT) ZPL II command (follow the instructions in the ZPL Programming Guide).

• When controlling printer operations with EPL Page Mode, refer to the Options (O)

EPL2 command (follow the instructions in the EPL2 Programmer’s Guide).

Your printer is now ready to print.

Thumb Wheel

DO NOT TOUCH

Ribbon Out Sensor

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 103 104

Sem comentários

Zebra TLP2824 Plus Guia do Utilizador Página 34