Zebra RW SERIES Especificações descarregar pdf (Página 67)

• 2-67 • RMAN-RWS-001 rev. B • RW Series Repair Procedures

Replacing the Platen Assembly

Remove the Old Platen Assembly

1. Remove and retain the two screws holding the Holder, Platen to the Media

Cover.

2. Carefully rotate the Holder, Platen towards the interior of the printer until it is

free from the media cover.

Caution•Avoidputtingstrainonthesensorcablewhichisadheredtotheinside

of the Holder, Platen. Do not exert excessive force on the Holder, Platen when it is

removed from the Media Cover.

3. Remove the Platen Assembly from the Holder, Platen.

Install the New Platen Assembly

1. Install the new Platen Assembly into the Holder, Platen, noting the location of

the Gear at “1”.

2. Rotate the Holder, Platen back into the Media Cover until it snaps into place as

shown at “2”. Ensure that the new Platen Assembly spins freely.

3. Secure the Holder, Platen to the Media Cover with the (2) retained Screws.

Replacement Kit RK17949-002- RW 220 Platen/Gear

Installation Instruction

This kit includes the parts and documentation necessary to install the RK17974-002

Platen/Gear Kit in the RW 220 model printer. Read these instructions thoroughly

before attempting to install this kit.

 Caution•TheoperatormustwearaproperlygroundedESDstraptoperformthe

following repair procedure.

Reference Materials

UMAN-RWS RW Series Users’ Guide

Tools Required

#0 or #1 Phillips Head Screw Driver

Cautions

 Caution•Thisinstallationmustbeperformedonlybyaqualiedservicetechnician.

Unless otherwise specied:

• Always turn the printer off

• Remove the battery before installing any Replacement Kits.

• Remove media before installing this Replacement Kit.

continued on next page

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 113 114

Sem comentários

Zebra RW SERIES Especificações Página 67