Zebra RW SERIES Especificações descarregar pdf (Página 73)

• 2-73 • RMAN-RWS-001 rev. B • RW Series Repair Procedures

Changing the Media Core Size

The printer is adjusted at the factory for media with a 3/4” core. If you need to use

media with a 1 3/8” core, do the following:

1. Remove and retain the Screw and Washer from a Media Support as described

above. Flip the Media Disk end-for-end, and reassemble to the Media Support

with the retained hardware.

2. Repeat this procedure for the other Media Support.

Note: The Media Support Disks should be replaced after they have been re-adjusted

fordifferentcoresizesatotalofve(5)times.

Screw, Self-Tap Pt. M3

x 6 Pan Hd. Phillip)

p/n TH-PTA023006-5

Washer, Flat #4

Reduced O.D.

p/n TH-WG0419

Disk Pick Up Media Support

p/n BA16937-1

Disk shown adjusted for 3/4” core.

RW 420 is illustrated. Procedure is the same for RW 220 models.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 113 114

Sem comentários

Zebra RW SERIES Especificações Página 73